Installing a bathroom faucet

How to install a bathroom faucet correctly?

How to install a bathroom faucet correctly? There are two ways to do this: find a plumbing specialist or try to do the job yourself. In the second case, you need to know the little secrets of installing the mixer.
Two pipe outlets protrude from the wall: for cold and for hot water. Usually there is an internal thread on the terminals. If the thread is external, you should screw in the adapters, on the terminals of which there is an internal thread. The external thread of the outlet is wrapped with tow, and the adapter is screwed with a wrench onto the pipe outlet.
When an internal thread appears at the outlet ends of the nozzles, a mixer can be mounted. It is necessary to take the eccentrics out of the box. The eccentrics have 1/2 male thread on one side and 3/4 male thread on the other. Tow is wound onto the 1/2" thread. This is done clockwise. The eccentrics are screwed into the pipe terminals. After screwing in, the bends of the eccentrics should be at the top.
Now you can get the mixer. In order to mount it on the eccentrics, it is necessary to slightly separate the bends of the eccentrics from the visual central axis, screw one of the union nuts, or rather, bait the nozzle and make sure that the second union nut of the mixer fits the second eccentric. If there is a mismatch, the eccentric is rotated with a 12 horn wrench until it matches the thread. After that, it is necessary to screw the mixer completely and check the accuracy of the thread match.
Next, the mixer must be removed and the eccentrics covered with decorative cups. This operation is done without any problems. Sealing gaskets must be installed in the inner cavities of the union nuts. There is no need to wind anything on the thread. If the eccentrics fit correctly, there will be no leaks, even if the nuts are tightened manually. The cap nuts must be tightened carefully, without exerting much effort, so as not to damage the gaskets and so that the nuts do not burst. After tightening the union nuts by hand, you need to turn on the water and check whether there is a leak or not, and then decide how tightly you need to tighten the nuts.
If the mixer reliably shuts off the water, you can mount the spout if it is not mounted in the mixer body. Then, a manual shower–spout switch must be installed on the upper side of the mixer, and a shower hose must be installed on the lower side. The joints are sealed with rubber gaskets, and the cap nuts are tightened by hand.
The last thing you need to install on the shower hose is a watering can. You need to connect it the same way – a cap nut with seals. The installation of the mixer is completed by mounting the shower holder on the wall. That's all. This is how the bathroom faucet is mounted. https://escortparis24.com/trans/